Avalon Firestyles 1080 CF Installation - Manual (Page 19)

Installation
(for qualified installers only)
19
© Travis Industries 4090807 100-01193_003
Battery Pack – Wireless Wall Switch Installation
•
The control panel must be mounted inside a junction box in a location that may be reached by
the 12’ long battery pack and DCMD wires (see Figure 11).
Staple the two wires near the junction
box. This prevents the wires from
slipping out of the junction box while
the batteries are replaced. Take care
to prevent damage to wires.
PRESS TO OPEN Latching Solenoid DC Motor Drive
Junction Box
(not supplied)
Battery
Pack
Wireless
Wall
Switch*
Cover
Plate
Battery Pack Wires (4)
DCMD Wires (2)
Receiver
Module
Gas Control
Valve
Wire Length = 12'
* The wireless wall switch may be located at a
separate location. An additional cover plate would be
required for the battery back junction box.
Do not route the wires over the top
of the fireplace.
Figure 11