Avalon Firestyles 1080 CF Installation - Manual (Page 22)

22 Installation
(for qualified installers only)
© Travis Industries 4090807 100-01193_003
INSTALLATION WARNING – Remote Synchronization
At this time we highly recommend you verify the remote and wireless wall switch are synchronized.
This process requires access to the receiver module – a component that is easily accessed when
the side of the fireplace is exposed. See the instructions on page 23 for details.
Battery Installation
This fireplace requires batteries for the remote, wireless wall switch, and battery box. We
recommend the batteies be replaced every year to insure proper operation. Follow the directions
below to install.
CR2032
The Wall Switch requires two (2) CR2032 3V
batteries (included).
NOTE: The positive side (+) faces outwards.
Battery Pack
(make sure this switch is
set to "DC Motor Drive")
Cover Plate
(snaps into place)
Wireless Wall Switch
Wall
CR2032
PRESS TO OPEN
Latching Solenoid DC Motor Drive AA Battery
AA Battery
AA Battery
AA Battery
The battery pack requires four
(4) AA batteries (not included)
AAA Battery
AAA Battery
The Remote requires two (2) AAA batteries (included)
Back of Remote
Figure 15