Avalon Firestyles 1080 CF Installation - Manual (Page 23)

Installation
(for qualified installers only)
23
© Travis Industries 4090807 100-01193_003
Remote Synchronization
The fireplace is shipped with the remote and wall switch pre-synchronized with the
receiver module on the fireplace. Do not synchronize the remote(s) unless you are
100% sure they do not work correctly.
The wall switch and remote have unique codes that allow them to communicate independently
with the receiver module on the fireplace.
Testing the Remote and Wireless Wall Switch for Synchronization
NOTE: The battery box, remote, and wall switch must have batteries to complete this process.
a
b
c
d
Press the "ON" button on the remote.
ON H/L
OFF
Continuous Pilot
MODE
SET
TEMP
°F
ON
OFF
HI
LO
Shut the gas off to the appliance.
The spark electrode on the pilot
assembly will start to spark*.
ON H/L
OFF
Continuous Pilot
MODE
SET
TEMP
°F
Press the "OFF" button
on the remote.
Press the "ON" button on
the wall switch.
The spark electrode on the pilot
assembly will start to spark*.
ON
OFF
HI
LO
e
Press the "OFF" button
on the wall switch.
* If either the remote or wall switch do not work properly, follow the steps to Synchronize the
remote and wall switch on the following page.
Figure 16