Avalon Firestyles 1080 CF Installation - Manual (Page 24)

24 Installation
(for qualified installers only)
© Travis Industries 4090807 100-01193_003
Synchronizing the Remote and Wireless Wall Switch
NOTE: The battery box, remote, and wall switch must have batteries to complete this process.
WARNING: Shut the gas off to the fireplace prior to conducting this process.
Use the reset rod (see instructions on
the following page) to press the reset
("Learn") button on the receiver module
until it beeps once.
ON H/L
OFF
Continuous Pilot
MODE
SET
TEMP
°F
POWER
AUX
Learn
Continuous Pilot
Off/On
Remote/Off
ADJ
Beep
Press the "OFF" button on the remote.
POWER
AUX
Learn
Continuous Pilot
Off/On
Remote/Off
ADJ
Beep, Beep,
Beep, Beep,
Beep
The receiver will acknowledge the
signal by beeping 5 times.
POWER
AUX
Learn
Continuous Pilot
Off/On
Remote/Off
ADJ
Beep
ON
OFF
HI
LO
Press the "OFF" button on the wireless
wall switch.
POWER
AUX
Learn
Continuous Pilot
Off/On
Remote/Off
ADJ
Beep, Beep,
Beep, Beep,
Beep
The receiver will acknowledge the
signal by beeping 5 times.
Use the reset rod (see instructions on
the following page) to press the reset
("Learn") button on the receiver module
until it beeps once.
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote or wall switch after two attempts, you
should re-set the receiver module. To do this, hold down the LEARN button on the reciever for
approximately 10 seconds until the receiver beeps 3 times. This indicates the receiver has been
re-set and can be synchronized using the instructions above.
The receiver module has enough memory to store three remotes. If you re-synchronize the
remotes, you may overwhelm the receiver memory, nullifying one of the earlier programmed
remotes. In these cases, you should reset the receiver module and re-synchronize.