Avalon Firestyles 1080 CF Installation - Manual (Page 54)

54 Finalizing the Installation
(for qualified installers only)
© Travis Industries 4090807 100-01193_003
6 Switch the pilot hood to the “LP” size following the directions below.
7/16" Wrench
Un-screw the pilot
hood 1/4 turn.
Slide this silver tab out.
When in the LP position a hole
will appear near one of the tabs.
Tighten the pilot hood
until it is fully secure.
Figure 34
NOTE: The sliding portion of the pilot orifice may be positioned differently. Instead of pulling it
towards you, you may push it away. Either way – when the hole appears near the tab, the orifice is
in the LP position.
7 Disconnect the burner tray and place it on the firebox floor (see Figure 35).
The burner tray is held
in place with 9 screws
(7 on the firebox wall, 2
on the pilot assembly).
Remove the burner tray
and place it on the
firebox floor.
The gas control valve and receiver
module are found on the back side of
this plate.
Figure 35