Bronkhorst E-7000 - Manual (Page 15)

BRONKHORST HIGH-TECH B.V.
9.17.004 page 15
2 INSTALLATION
2.1 General
2.1.1 Receipt of equipment
Check the outside packing for damage incurred during shipment.
Should the packing box be damaged, then the local carrier must be notified at once regarding his liability, if
so required.
At the same time a report should be submitted to
BRONKHORST HIGH-TECH B.V.
RUURLO HOLLAND
Remove the envelope containing the packing list; carefully remove the equipment from the packing box.
Do not discard spare or replacement parts with the packing material and inspect the contents for damaged or
missing parts.
2.1.2 Return shipment
When returning material always describe problem and if possible the work to be done in a covering letter.
Important:
Do clearly note, on top of the package the custom clearance number of Bronkhorst High-Tech B.V.,
namely:
NL801989978B01
2.1.3 Service
If this equipment is not properly serviced, serious personal injury and/or damage to the equipment could
result. It is therefore important that servicing is performed by trained and qualified service personnel.
Bronkhorst High-Tech B.V. has a trained staff of servicemen available.
2.1.4 Installation
Before switching on power, please check if all external electrical connections with sensor/controllers and
FLOW-BUS (if necessary) are properly connected (consult Customers System Description).
If you receive a readout unit including sensor/controllers, the total system has been tested in full operation
under the nearest process-conditions.
For the electrical connection between sensor/controller and readout unit it is recommended to use the
standard Bronkhorst HI-TEC cable, which is an eight conductor shielded cable, complete with connectors.
2.1.5 Configuration
All readout and control modules are factory set, for the used Bronkhorst High-Tech sensors/controllers, as
described in your customer system description (see appendices).
2.1.6 Equipment storage
The equipment should be stored in its original packing in a cupboard warehouse or similar. Care should be
taken not to subject the equipment to excessive temperatures or humidity.