Bronkhorst E-7000 - Manual (Page 62)

BRONKHORST HIGH-TECH B.V.
page 62 9.17.004
NOTE 2:
Make sure this module has been switched-off before connecting it to the FLOW-BUS.
First make FLOW-BUS connection, then switch-on the power. Only in this order the module is able to
perform its communication checkings properly.
In case of the hand held version the module is powered by the FLOW-BUS. The module will automatically
switch-on when it is connected to the FLOW-BUS.
How to install the E-7000 modules on the FLOW-BUS network, see manual 9.17.024.