Bronkhorst E-7000 - Manual (Page 47)

BRONKHORST HIGH-TECH B.V.
9.17.004 page 47
Menu descriptions
3100 0000 Reset Alarm.
Here you can reset an alarm if it is active. This will result in removing the alarm situation defined
to take place at the potential free contact and/or at the (temporary) alarm setpoint. If the alarm
condition is still present, the alarm will activate again after a few seconds until alarm condition is
removed (flow/pressure input signal into save area again) or when alarm mode will be changed.
3200 0000 Reset Counter.
Here you can reset the counter. This will result in setting the counter to value 0 and evt. removing
the alarm situation defined to take place at the potential free contact and/or at the (temporary)
alarm setpoint. Counter will proceed when counting mode has not been changed.
3300 0000 Password input location.
Here you can enter a password to be allowed to edit the counter, alarm, instrument and FLOW-
BUS configurations. The password consists of 5 characters and can not be changed. Cursor can
be controlled with LEFT/RIGHT keys. Characters can be selected with UP/DOWN keys. When
password has been entered correctly, you have access to all menu's and it is possible to change
settings for an instrument. Without password input it is only possible to operate an instrument.
Password will be erased and access to settings-menu's will be denied when:
1) Module has been switched-off and on again (at power-up).
2) A wrong password has been entered.
3) Automatically after 3 minutes when no key has been pressed.
Password is: ABABC and can not be changed.