Bronkhorst E-7000 - Manual (Page 41)

BRONKHORST HIGH-TECH B.V.
9.17.004 page 41
Menu descriptions
0000 0000 Startup screen showing message loading parameters.
0001 0000 Startup screen showing company name.
0002 0000 Startup screen showing communication check with FLOW-BUS in progress. Takes a short time
(few seconds), depending on system size. If the FLOW-BUS address of the module is occupied,
you can reinstall the module on a new address.
0003 0000 Startup screen showing software revision level
0004 0000 Startup screen checking operating instrument. If there is no instrument found on the current
instrument node and the MULTI CHANNEL mode is activated, the E7000 module starts
searching for an other instrument on the bus.
0005 0000 Startup screen showing operating instrument if available.
1000 0000 Measure menu or ‘Readout Display’ for reading the amount of flow/pressure, setpoint and/or
counter value. When there is an alarm- or counter limit reached it will be shown here. For editing
the setpoint/slave factor go down one level.
2000 0000 Operation menu for selecting setpoint source (and master/slave), fluidset and setpoint slope for
the device to be operated. Also for editing setpoint offset.
3000 0000 Reset menu for quick reset of counter and alarm by keyboard. Also password input location to
enable advanced use of this module.
4000 0000 Counter menu for configuration of all counter options. This menu is secured by means of a
password.
5000 0000 Alarm menu for configuration of all alarm options. This menu is secured by means of a
password.
6000 0000 Instrument menu for configuration of the instrument to be operated, such as instrument type,
capacity, sensor type, identification and fluid sets with calibration values. This menu is secured
by means of a password.
7000 0000 Readout menu for configuration of the measure menu. You can select the wanted information for
your display.
8000 0000 FLOW-BUS menu to install module on the FLOW-BUS or start/stop communication with the bus.
This menu is secured by means of a password.
F000 0000 Searching instruments. One can search on the bus for instruments with the
↑
and
↓
keys. An
instrument can be selected by pressing enter. This option is only available when the MULTI
CHANNEL mode is activated.
NOTE:
When you press ‘enter’ in one of the above menu-options, the module jumps to startup screen ‘0004 0000’
and checks the communication with the operating instrument and shows its serial number.
The MULTI CHANNEL mode can be activated in LOCAL MENU - TERMINAL MODE.