Bronkhorst E-7000 - Manual (Page 19)

BRONKHORST HIGH-TECH B.V.
9.17.004 page 19
Menu descriptions
0001 0000 Startup screen showing company name
0002 0000 Startup screen showing communication check with FLOW-BUS in progress. Takes a short time
(few seconds), depending on system size. If the FLOW-BUS address of the module is occupied,
you can reinstall the module on a new address.
0003 0000 Startup screen showing software revision level
1000 0000 Measure menu or ‘Readout Display’ for reading the amount of flow/pressure, setpoint and/or
counter value. When there is an alarm- or counter limit reached it will be shown here. For editing
the setpoint/slave factor go down one level.
2000 0000 Operation menu for selecting setpoint source (and master/slave), fluidset and setpoint slope for
the device to be operated. Also for editing setpoint offset.
3000 0000 Reset menu for quick reset of counter and alarm by keyboard. Also password input location to
enable advanced use of this module.
4000 0000 Counter menu for configuration of all counter options. This menu is secured by means of a
password.
5000 0000 Alarm menu for configuration of all alarm options. This menu is secured by means of a
password.
6000 0000 Instrument menu for configuration of the instrument to be operated, such as instrument type,
capacity, sensor type, identification and fluid sets with calibration values. This menu is secured
by means of a password.
7000 0000 Readout menu for configuration of the measure menu. You can select the wanted information for
your display.
8000 0000 FLOW-BUS menu to install module on the FLOW-BUS or start/stop communication with the bus.
This menu is secured by means of a password.