BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 18)

1 8
After powering up, the FDS-355 performs internal checks and sets up the audio
path before releasing the output mute relays. This takes a few seconds.
Refer to section 6.0; Default screen.
Key screens
The stereo link screen shows whether the unit is operating in a linked mode or
not.
Refer to section 7.0; Utilities menu.
The configuration screen changes the output mode of the unit.
Refer to section 7.0; Utilities menu.
The MIDI details screens allows the user to select the MIDI channel and the
MIDI mode of the unit.
Refer to section 7.0; Utilities menu.
Input settings Pushing the parameter wheel again (at any time in the Default or Utilities
menu) will enter Inputs Mode. Here the parameters of each input can be
adjusted.
The delay screen shows the delay value set for each input.
Refer to section 8.0; Inputs menu.
The next screen allows the user to edit the filter parameters in the following
order: EQ shape, Frequency, Cut/Boost, and Width. Each filter is dealt with on
a seperate screen. Therefore, all of the first filter parameters will be accessed
before moving on to the parameters of the second filter, and so on...
Refer to section 10.0; EQ screens.
Utilities Pushing the UP key will enter the Utilities Mode. Many of the utility screens
are self explanatory (see Screen layout on the previous two pages), but the
more important ones are shown below.
The display shows the currently selected utility at the top of the screen, and
the previous 3 available utilities underneath.