BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 33)

33
giving you the option to turn off the lock if you wish to overwrite the existing
program.
There are 3 ways in which data can be stored, and these are indicated by the
STORE TYPE message at the top of the display. To highlight the Store type
message, use the DOWN key while a program number is highlighted. Once
highlighted, turn the parameter wheel to select the type of store you wish to
use.
INT
This stores the program in the internal memory of the unit.
CPrg
This stores the currently selected program to a PC card (if inserted) in the slot
at the front of the unit.
CAll
This stores all program data to a PC card (if inserted) in the slot at the front of
the unit.
The Program Lock can be applied to a program stored using any of these 3
methods.
NOTE: The edit flag appears when there are unsaved changes to a program,
compared to the initial status of the last recalled/stored program (Internal
memory only). When a program is stored to internal memory, the edit flag will
disappear. If a program is stored to a PC card, then the flag will NOT
disappear, since there are differences between the last recalled/stored
program (Internal), and the current program.
STORE TYPE
Once the program name has been entered, the store type selected, and the
Program lock status cleared, pressing the STORE key again will prompt the
message "STORE UNLOCKED?", asking whether the program should be stored
with a Program lock on/off. Use the parameter wheel to turn the Lock on/off,
the default setting being ON. Once the Lock status is set, push the STORE key
a final time to commit the program to memory (or PC storage). The display
will now default back to the screen displayed before the STORE facility was
accessed.
To exit from the store screen without storing a program, press the recall
button.
11.2 Recalling Pressing the RECALL key will access the recall screen. This facility is
displayed in the same way as the store facility.
The parameter wheel is used to select the program number to recall (when
highlighted), or to select internal memory or PC card recall (when
highlighted). The UP/DOWN keys are used to toggle between Program
number and Recall type.
When the program you wish to recall has been selected, push the RECALL key
again to recall the program. The unit will display a message showing that data
is being recalled, and will then display the default screen once the recall is
complete.
To exit from the recall screen without recalling a program, press the store
button.