BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 25)

25
8.0 Inputs Menu
There are three inputs available for routing to outputs plus an internal mono
sum of inputs A and B, referred to as A+B. This gives the Input Channels:
A, B, A+B, and C.
The facilities described in this section are common to all inputs, except EQ,
which is not possible on the mono sum A+B signal.
The first screen in the input menu is the DELAY SCREEN. Pressing the UP key
will access the EQ screens.
The delay on each input channel can be adjusted individually, in 11
microsecond steps. Turning the parameter wheel will set the amount of delay
required on the input. This delay is typically used to set the delay for delay
towers etc, or to stagger the delays between the left and right channels to
‘move’ sound lobes in an installation.
Delays can be viewed and adjusted in metres (default), feet/inches, or
milliseconds. Refer to section 7.0; Utilities menu.
Note: The maximum delay value is restricted by any delay on an output
which the current input feeds.
EQ To add EQ to an input, step through the functions on the desired channel using
the UP/DOWN keys until you reach the screen that shows the EQ parameter
you wish to edit. Refer to section 10.0; EQ screens for more information on
editing EQ parameters.
Inputs menu
Delay