BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 19)

19
Output settings
The name screen. Allows each output to be given a descriptive name from a
preset list.
Refer to section 9.0; Outputs menu.
The source screen allows the user to configure the routing of the inputs to the
outputs.
Refer to section 9.0; Outputs menu.
The Limiter and Gain screens allow output gain and limiter settings to be
changed.
Refer to section 9.0; Outputs menu.
The Delay and Delay Link allow delay to be applied to the each output, and
also allow linking for changing delay on multiple outputs simultaneously.
Refer to section 9.0; Outputs menu.
The Xover screens allow each edge of the crossover point to be adjusted,
using the following parameters: Polarity, Phase, Low and Hi Filter shape, and
Low and Hi crossover frequency.
Refer to section 9.0; Outputs menu.
The next screen allows the user to edit the filter parameters in the following
order: EQ shape, Frequency, Cut/Boost, and Width. Each filter is dealt with on
a seperate screen. Therefore, all of the first filter parameters will be accessed
before moving on to the parameters of the second filter, and so on...
Refer to section 10.0; EQ screens.
Pushing the parameter wheel again (at any time in the Outputs menu) will
return to the Default/Utilities screen.