BSS Audio FDS-355 OMNIDRIVE Owner's Manual - Manual (Page 32)

3 2
11.0 Store and Recall
Storing and Recalling a program can be done at any time using the STORE
and RECALL keys on the left hand side of the LCD, unless Backup and Swap
(see section 7.0; Backup and swap) has been turned on. The FDS-355 can hold
60 programs internally, and these can also be saved to a PC card (refer to
section 16.0; PC Card). At any time, the Default values of the unit can be
restored by recalling program 0, except when Owner Lock is turned ON.
NOTE: If the unit is prompting for confirmation of an action at any time, the
STORE key is used to conform the action, and pressing it at this point will not
access the STORE facility.
11.1 Storing Pressing the STORE key will access the Store screen.
Use the UP/DOWN keys (or push the parameter wheel) to move along the
program name, and also between the program name and the STORE type at
the top of the screen.
While the Program number is highlighted, turning the parameter wheel will
cycle through programs 1-60.
While each of the letters in the Program name are highlighted, turning the
parameter wheel will cycle through all available characters. Note that the
letters in the program name being edited (at the top of the screen) are more
spaced out than other program names on the screen.
The last space in the program name is reserved for Program lock. Turning the
parameter wheel will turn this on/off. If a program has this flag set to on (so
the program name displays a key at the right hand side), a new program, or
edited version of the current program, cannot later be stored in this location.
This lock can be turned off at any time in order to delete or overwrite the
program. If you try to store a program in place of a locked program, the unit
will display "PROGRAM LOCKED!", but will then highlight the key icon,
Program Name
STORE type Unsaved changes
flag
Store and Recall
Program Lock
status
OEM Program
Program number