Cadac S-Type - Manual (Page 23)

Mono input module 8411 4-5
Revision S2005-6 S-Type
)URQW#SDQHO#0#PRQR#LQSXW#FKDQQHO#PRGXOH#;744
71414: 9&$#*3#0#$VVLJQPHQW#9&$#0DVWHUV
Using these buttons you can assign any of the eight VCA masters to any of the
inputs. This enables you to control the module’s output and mute via the applicable
VCA Master fader and mute controls. Normally, you would assign an input channel to
one VCA Master, it is, however, possible to assign the input channel to two or more
VCA Masters, should this be required.
71414; +3)#0#+LJK#3DVV#)LOWHU#,Q22XW
Pressing the HPF button will insert the high pass filter into the signal path. The HPF
has a cut-off frequency of 160Hz, with a slope of 12dB per octave. Note that the HPF
is situated immediately after the microphone amplifier and is not switched with the
equalizer.
71414< (4#0#(4#,Q22XW
Press this button to switch the equalizer in circuit.
714153 (4#35(#0#(4#35(#EXWWRQ
Normally the equaliser is situated after the channel insert. Pressing the EQ PRE but-
ton will put the EQ before the channel insert.
4.1.21 HF EQ Cut/Boost & Frequency
control 1k5Hz - 15kHz
4.1.22 HF Q-control
4.1.23 HMF EQ Cut/Boost & Frequency
control 400Hz - 4kHz
4.1.24 HMF Q-control
4.1.25 LMF EQ Cut/Boost & Frequency
control 600Hz - 60Hz
4.1.26 LMF Q-control
4.1.27 LF EQ Cut/Boost & Frequency
control 200Hz - 20Hz
4.1.28 LF Q-control
4.1.17 Assignment VCA Masters
4.1.18 HP-filter button with LED
4.1.19 EQ-button with LED
4.1.20 EQ Pre button with LED