Cadac S-Type - Manual (Page 39)

Group, matrix and aux output - stereo 8413, mono 8415 6-1
Revision S2005-6 S-Type
9 *URXS/#PDWUL[#DQG#DX[#RXWSXW#0#
VWHUHR#;746/#PRQR#;748
Each console can have up to 6 x 8415 and 2 x 8413 (note that the illustration depicts
the stereo version) which will give you access to all the available Group, Matrix and
Auxiliary outputs of the desk.
Each group module comprises of a sub-group output with a full size P&G fader, 12-
segment meter, PFL, Mute and Insert. It is possible to send the sub-group signal to
the stereo bus with panning. In addition, there is a switch to change the send to
matrix to be pre rather than post sub-group fader.
The matrix sends on the module consists of 8 individual routing buttons and four dual
concentric potentiometers for the send level - odd send (upper control), even send
(lower control). This leads to the Matrix master output, which has a potentiometer for
output level control, 12-segment meter, PFL, Mute and Insert.
The final output on the module is the Auxiliary Master output, which comprises of a
potentiometer for level control, 12-segment meter (2 in the case of the stereo 8413),
PFL and Mute.
Inputs and outputs are electronically balanced on 6.3mm jack sockets, except the
sub-group and Matrix master outputs that are available on XLR connectors.
The module mix bus coding for the Sub-group, Matrix and Auxiliaries is manually
selectable using 4-way jumpers (8-way for the two stereo auxiliary masters). For
details on this, see
B. Mix bus coding
The VCA Master is located at the bottom of the module and consists of a 100mm
P&G fader and mute control.