Daktronics Remote Control System RC-100 - Manual (Page 69)

CAN Handheld Operation 61
Section 17: CAN Handheld Operation
This section describes operation details specific to CAN (Controller Area Network) handheld
operations. CAN handheld functionality is used when handheld operation is controlled by a device
on the CAN network such as the OmniSport 2000 timing console. Refer to Drawing A-230608 in
Appendix A for typical CAN setup information.
17.1 Common CAN Handheld Operation
Display Action
When the message at left is shown on the LCD, the
Base Station is waiting to be connected to an external
device on the CAN network.
When a CAN device is detected, the LCD will update to
show application-specific information.
17.2 Diving & Synchronized Swimming Operations
Sport Insert: LL-2606
Refer to the Judge’s Console section of the OmniSport 2000 Timing Console Operations
Manual (ED-13312) for application-specific operation instructions.
17.3 Rodeo Operations
Sport Insert: LL-2608
Refer to the Judge’s Console section of the OmniSport 2000 Rodeo Timer Operations
Manual (ED-14843) for application-specific operation instructions.
WAI TI NG FOR
EXTERNAL CONTROL