Daktronics Remote Control System RC-100 - Manual (Page 71)

Troubleshooting 63
Section 18: Troubleshooting
18.1 Handheld Controller Error Messages
Display Cause/Solution
NN = current setting
The wireless handheld could not find a server on the
specified channel.

Make sure the wireless Base Station is powered
on, and is set for the specified channel.

Make sure the handheld is within minimum and
maximum range limits (refer to Section 2).

Press <ENTER> to retry the connection (if the
handheld was just moved in range or the
wireless Base Station has been correctly
configured).

Press <CLEAR> to set the channel number to a
different channel and retry.
NN = current setting
The wireless handheld did find a server on the specified
channel, but the server did not respond.

Make sure the handheld is within minimum and
maximum range limits (refer to Section 2).

Cycle power to the wireless Base Station and
retry the connection.

Make sure that there are no other wireless Base
Stations within range on the same channel.
Try a different channel if necessary.

Press <ENTER> to retry the connection (if the
handheld was just moved in range or the
wireless Base Station has been correctly
configured).

Press <CLEAR> to set the channel number to a
different channel and retry.
The message at left is displayed if another wireless
handheld controller is currently connected to the Base
Station and the application does not permit multiple
handheld units.
Power off any other unused handheld units on the same
channel in the area (refer to Section 4.1).
NO SEVER FOUND
ON CHANNEL NN
ENT TO RETRY
CLEAR SETS CHAN
NO RESPONSE
ON CHANNEL NN
ENT TO RETRY
CLEAR SETS CHAN
ERROR - THI S
CHANNEL I N USE