Digi-Star TCX-1000 SERIES - Manual (Page 11)

D3556 05/29/03 REV. 2.2 Copyright 2001
11
A. ENTER TIME, DATE SETTING MODE
The setup can be accessed at power on, by pressing the ECS key once during the segment test,
“t-DAtE” will be displayed. Press the ON/POWER key from any mode to display segment test.
Press the ENTER key to display the first Time/Date setup step, or press ESC to cycle through the
user menus. Pressing ESC will take the user to each of the configuration heading. Pressing Enter
at any of the headings or subheading will cause a value to be recorded and the new submenu item
to be displayed. If Enter is pressed at the bottom of a sub-category, the next main category will be
displayed.
B. USING THE KEYPAD TO SET THE TIME AND DATE
To change the values of time and date:
Use: “0”-“9” to enter numeric values for steps displaying a blinking digit.
NO/CLEAR to clear the last digit to 0.
↑ to select the next option from a list of options, if a list of options applies. Otherwise use the
numeric keypad.
↓ to select the previous option forms a list of options, if a list of options applies. Otherwise use
the numeric keypad
ESC to abort entry of the prese
nt step and restart the menu.
NOTE: Press the ENTER key to save the new value. A new entry will be stored only by pressing
ENTER, even though there are other ways to exit a step.
C. SETTING TIME & DATE
Press the POWER / ON button
While the indicator is in all 8’s press the ESC button. The upper display will now show t-dAtE
Press the YES/ENTER button once and the lower display will show the current time in military
24hr format. The time displayed may look something like this:
ti
15:21
This would correspond to 3:21 p.m. ti:hh:mm hh= Hours mm= Minutes
Key in the new time, in 24hr format, using the keypad on the front panel of the indicator. Once
you press the first digit of the time you are to enter, the time will become 00:00 with the rightmost
digit replaced by the number just entered.
Key in the rest of the digits and after all the digits have been entered, press the YES/ENTER
button. Be shure not to press YES/ENTER between the digits. After the YES/ENTER button has
been pressed, the date will be displayed in the format:
03:14:01
Which corresponds to March 14, 2001 and the rightmost digit will be blinking.
Date Setting mm: dd: yy mm=month dd=day yy=year
Key in the new date using the keypad on the indicator pressing YES/ENTER once all the digits
have been entered. To erase an incorrect digit, pressing the NO/CLEAR button and that digit will
disappear.