Viii. security code entry – Digi-Star TCX-1000 SERIES User Manual
Page 33
D3556 05/29/03 REV. 2.2
Copyright 2001
33
Press [YES / ENTER], the indicator should display “BuSy” followed by
“
888888
” then go into Gross Weighing mode.
The Gross Weight on the display should be equal to the calibration weight which was just
put into the truck/wagon. When calibration weight is unloaded --- the indicator will
display a number very close or equal to “0”.
Calibration is complete!
( Call Digi-Star’s service department at (920) 563-9700 for further assistance. )
VIII. SECURITY CODE ENTRY
The SECUrE display indicates that a password must be entered into the indicator to allow the configuration
and calibration menus to be accessed. In order to proceed, you must press the Enter key to display
SEC=00. Use the “?” and “?” keys to enter the first security code, then press the Enter key. The display will
again show SEC=00. Now enter the second security code. After the second security code has been
entered, if it matches the user defined security code, the configuration step will be displayed. Otherwise
the TCX 1300 will return to a menu that is not Security protected. There is a provision to have a user
definable security code in addition to the factory default. This allows the scale installer to set a code that
will allow a user to access the configuration and calibration should it become necessary. This user
definable access code can be changed as often as necessary with the factory default value always constant.
SPECIFICATIONS
The TCX 1300 Digital weight indicator is a microprocessor based general purpose instrument.
FEATURES
• The following features are standard on all models:
• Selectable digital averaging
• Auto zero tracking, selectable from .5 to 3 graduations
• Push button zero, selectable from 2% to 100% of capacity
• Function keys: zero, print, units, net/gross, esc, no/clear, yes/enter, auto tare, set point, ID#/recall, acc
Pt/alarm.
• Units Conversion, selectable pounds or kilograms
• 2 Serial Outputs:
one duplex ASCII RS-232C outputs,
one simplex ASCII RS-232C outputs