Digi-Star TCX-1000 SERIES - Manual (Page 25)

D3556 05/29/03 REV. 2.2 Copyright 2001
25
B. CONFIGURATION INSTRUCTIONS
Press the program key “SW1” from any mode to display internal counts. This key is located on
the opposite side of the TCX 1300.
Press the enter key to display the first configuration menu setup, or press ESC to cycle through the
calibration menus.
C. TO ENTER VALUES IN THE CALIBRATIONS MENUS
Use 0 – 9 to enter numeric values for steps displaying a blinking digit.
“Clear” to clear the last digit to 0
↑
to select the next option from a list of options
↓
to select the previous option from a list of options
ESC to abort entry of the present step and restart the menu
ENTER to save the value and go to the next step
AUTO=n NO AUTO CONFIG
AUTO=1 TRUCK SCALE
AUTO=2 FLOOR SCALE
AUTO=3 ON-BOARD WEIGHING
Note: Auto=1 and Auto=2 are preset configurations and printer formats for use with truck
platform and/or floor scales. The values thus selected are shown in the far right columns of this
table. By far the option used most for on-board weighing is that of the Auto=3. The indicators
come from the factory with an Auto=3 setting. If an individual option is to be changed, graduation
size for example, do not set the indicator to Auto=3 unless all other setting are desired to be
changed back to factory defaults. Use the Auto=n setting and once the chosen option has been
modified, press the Yes/Enter button until the Pdn=no option is displayed. This insures that the
changes have been recorded into memory.