Kanguru 4HD SATA - Manual (Page 13)

13
3.1.1 Disk Copy
The Disk Copy function clones hard drives sector-by-sector from the Master to the Target(s) and
supports all data formats. This mode is slower than other modes but it is also the most reliable copy
method. Disk Copy is the default COPY function.
Note: When performing a Disk Copy, Kanguru Solutions recommends using Master and the Target
disks of the same capacity. If you want to clone a Master hard drive to Targets of a different capacity,
please use the Resize Copy function. For more information on Resize Copy, please see section 3.1.3
Resize Copy, p.15.
COPY
DIAGNOSTIC
TOOL
->
<- Back UP/DN Sel ->
[ ] DISK COPY
[ ] BRIEF COPY
[ ] RESIZE COPY
->
<- Back UP/DN Sel ->
X
[COPY]
DISK COPY
Run by ‘>’
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to COPY mode. Press the RIGHT button to enter
COPY mode.
2. From the COPY Function Menu, press the UP or DOWN
buttons to navigate to the DISK COPY function. Press the
RIGHT button to select DISK COPY.
3. Press the LEFT arrow twice to return to the Main Menu.
4. Press the RIGHT button to begin the Disk Copy.
5. Once the KanguruClone has finished cloning, it will display
a “V” for verified target drives or an “X” for failed drives.
Disk Copy