Kanguru 4HD SATA - Manual (Page 20)

20
3.1.8 Area Compare
The Area Compare function only compares the sector defined by an Area Copy.
Note: Compare functions can only be used when the UDMA transfer mode is disabled. To disable
the UDMA you have to enter the CONFIGURATION mode, select TRAN MODE and then define
the Transfer Mode as “UDMA0”. For more information on Transfer Mode, please see section 3.4.2
Tran Mode, p.35.
COPY
DIAGNOSTIC
TOOL
->
<- Back UP/DN Sel ->
[ ] DISK COMPARE
[ ] BRIEF COMPARE
[ ] AREA COMPARE ->
<- Back UP/DN Sel ->
X
[COPY]
AREA COMPARE
Run by ‘>’
1. Leave all drives in place after an Area Copy session has
completed.
2. From the Setup Menu, press the UP or DOWN buttons to
navigate to COPY mode. Press the RIGHT button to enter
COPY mode.
3. From the COPY Function Menu, press the UP or DOWN
buttons to navigate to the AREA COMPARE function. Press
the RIGHT button to select AREA COMPARE.
4. Press the LEFT arrow twice to return to the Main Menu.
5. Press the RIGHT button to begin the Area Compare.
6. Once the KanguruClone has finished comparing, it will
display a “V” for verified target drives or an “X” for failed
drives.
Area Compare