Kawai MP6 - Manual (Page 33)

33
5
. C
o
n
trol Knobs
The default parameters assigned for each knob are as follows.
A: #10 Panpot (PAN)
B: #70 Sustain Level (STN)
C: #76 Vibrato Rate (VbR)
D: #77 Vibrato Depth (VbD)
Note:
If the selected zone is set to BOTH, changing the MIDI CC# parameters affects both
internal and external sections. If you want different settings for internal and external
sections, enter the edit mode by pressing the MENU button and select internal or
external section with the ZONE SELECT button. (See page 35 for details.)
Changing MIDI CC parameter
Press and hold the ASSIGN button. ASSIGN button starts blinking and the cursor
in the display moves up to the parameter name.
1 PA
-
N STN VbR VbD
0
0 0 0
Use the CONTROL KNOBS to change the parameters.
After changing the parameter, press the ASSIGN button again. The ASSIGN
button stops blinking and the cursor in the display moves down to the value.
If “AFT” is selected, the modulation wheel is used to send After Touch
information.
Note:
When the selected zone is set to INT, only the following parameters can be
selected.
10 Panpot PAN
70 Sustain Level STN
71 Resonance RSN
72 Release RLS
73 Attack ATK
74 Cutoff CUT
75 Decay DCY
76 Vibrato Rate VbR
77 Vibrato Depth VbD
78 Vibrato Delay VbY
93 Chorus Depth ChD
When the selected zone is set to BOTH and the internal section is selected in edit
mode, the parameters not available for INT section show as “ XXX”.
1 015 STN VbR VbD
I xx
-
x 0 0 0