Kleenmaid BBQ3BF - Manual (Page 10)

10 Kleenmaid Professional - Outdoor Cooking Centres
Assembly Notes
Before any assembly or installation is attempted it is
important that you check for damage or missing parts.
Your dealer or the manufacturer must be notified of
any problems immediately before proceeding.
The main frame of the barbecue has been factory
assembled requiring only the following simple steps
for completion. Check the “Gas Type “ label attached to
barbecue and side burner to be certain this Gas Type
is the one required for your use eg. Propane / LPG or
Natural Gas. See Fig 2
Trolleys, roasting hoods and side burners are optional
so read this manual in conjunction with the manual
that comes with each accessory. Assemble the trolley
first before attaching any other components. Attach
the roasting hood last of all.
Assembly Procedure
Heat Reflectors, Burners And Vaporizers
The modular Vaporizer Grid system has been designed
to maximise the performance of your barbecue.
The reflectors fit between each burner. They reflect
heat from the burners, upwards to the cooking
surfaces.
The Vaporisers are designed to vaporise fats and
juices from the meat. One Vaporizer is fitted over
each burner that is located under the grill. The
Vaporizers reduce flare-ups and help to add that great
barbecue flavour.
Fitting The Heat Reflectors
Completely remove all of the plastic film from the
Reflectors. The tabbed ends of the heat reflectors
face forward to the front of the barbecue frame. The
tabs fit into the slots in the front end of the barbecue
(behind the control fascia). Key the tabs of the
Vaporizers into the lower slots (between the burners).
Key the tabs of each reflector into the slots. If slots are
partially covered with enamel, work the tabs until the
enamel clears. See Fig 8.
Fitting The Burners
Remove the retaining clips from the burners, then
fit the burners - open end first, over the brass stem
of the control valves at the front of the barbecue,
allowing the rear burner lug to locate into the cross-
lighting channel and corresponding hole in the
support panel at the rear or the barbecue. To secure
burners fit retaining clips (“R” shape) into burner lugs.
See Fig 9 & 10.
Fitting The Vaporizers
Remove the protective plastic film from each
Vaporizer and then fit the Vaporizers to the barbecue.
The tabbed ends of the Vaporizers face forward to the
front of the barbecue frame. The tabs fit into the slots
in the front end of the barbecue (behind the control
fascia). Key the tabs of the Vaporizers into the upper
slots. The vaporizers should be fitted to the same side
of the barbecue to which the grill is to be placed (they
will not work if fitted under the plate). If slots are
partially covered with enamel, work the tabs until the
enamel clears. See Fig 11 & 12.
How Many Vaporisers & Reflectors Are There
Model Vaporiser Reflector
3 Bnr 2 2
4 Bnr 3 3
5 Bnr 4 4
Assembly Instructions
Fig 6
Fig 7
Fig 8
Fig 12
Fig 11
Fig 6