Kleenmaid BBQ3BF - Manual (Page 9)

Kleenmaid Professional - Outdoor Cooking Centres 9
Gas Cylinder Safety Information
This appliance is designed to be used with a gas
cylinder not exceeding 10 kg.
The Gas cylinder must be constructed and marked in
accordance with specifications for LP Gas Cylinders.
The gas cylinder supply valve must be turned off when
the appliance is not in use.
Gas cylinders must be stored outdoors, out of reach
of children and must not be stored in a building,
garage or any other enclosed area.
The gas cylinder used must incorporate a safety collar
to protect the valve assembly.
Important:
When disconnecting and removing the gas cylinder for
the purpose of refilling, always observe the following
procedure.
Ensure that all gas control valves on the appliance and
the gas cylinder are turned off before disconnecting
the gas line from the cylinder.
Do not smoke or use a naked flame near the appliance
or gas cylinder while disconnecting the gas line
between the appliance and gas cylinder.
Remove the gas cylinder from the enclosure before
disconnecting the gas line from the appliance.
Tighten all connections before placing the gas cylinder
back in its enclosure.
The Gas Leak Testing Procedure should be conducted
every time the gas cylinder is refilled and reconnected
to the appliance - before using the appliance.
Regulator Connection (Fig 3 & 4)
1. Check that all control knobs are in the Off position.
2. Make sure the cylinder valve is off by turning the
valve knob clockwise.
3 Remove the protective cap from the cylinder if
present.
4. Leak test the connection with a soapy water
solution. (See Gas Leak Testing Procedure)
Hose and Regulator replacement must be a genuine
part specified for this appliance and is obtainable
from your nearest stockist.
Gas Leak Test Procedure
Use the following procedure to check for gas leaks.
Never use a naked flame to check for gas leaks.
1. In a small container, mix up a solution of water
and detergent or soap. Mix the solution well.
2. For LPG make sure that the gas supply valve on the
gas cylinder is turned on. For NG make sure that
the gas line is correctly fitted to the appliance.
3. Make sure that the gas control valves on the
appliance are all turned off.
4. Using a brush or spray bottle apply the solution to
the gas line and each join in the gas line including
the hose and regulator connection.
5. Bubbling of the solution will indicate that there is a
leak present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or
the manufacturer for assistance. See Fig 5
Assembly Instructions
Fig. 5
Fig. 3
Fig. 4
Forming bubbles indicate
that a leak is present