4 gauge (instaset bar) setting, Gauge (instaset bar) setting – MBM Corporation AEROCUT NANO User Manual
Page 10
AeroCut nano OPERATION MANUAL
10
2.4 Gauge (InstaSet bar) setting
・Select the right InstaSet bar
according to desired cut pattern.
Gauge
(InstaSet bar)
① Loosen the slitter head lock knobs.
② Slide the slitter head with holding the knob.
Adjust the positions of the slitters so that their pins fit to the U-notches on the
InstaSet bar. Snap the InstaSet bar with the labeled side on top and adjust it so that
its pointer points 0.
③ Tighten the screws.
④ Tighten the slitter head lock knobs.
Slitter head lock knob
Tight
Loose
Slitter head
Gauge
(InstaSet bar)
Screws x2
U-notch
Scale
Pointer
①
④
②
③
Pin
・Some cut patterns do not require to use
all the slitter units.
In such cases, slide the unnecessary
slitter head(s) to side trench and tighten
the slitter head lock knob(s).
Don’t use the head
Lock knob