MBM Corporation AEROCUT NANO - Manual (Page 24)

AeroCut nano OPERATION MANUAL
24
6 Error messages
1. Safety cover ( Page 6) might be
open.
Make sure to close the Safety cover
closed.
2. Timeout error 1
Paper was not fed within a set time
period.
Check the paper feeder.
3. Timeout error 2
Paper did not pass through within a set
time period.
Remove the paper remaining inside the
machine.
4. Check the paper or paper path.
5. Cutmark was unable to be detected.
Check the cut mark.
Eject the paper inside the machine.
Note.
Cut-mark sensor detects the black mark
by infrared light. Some types of toner
or ink may reflect the infrared light and
cause the sensor not reading the
cut-mark. Please inactivate the
cut-mark registration in such cases.