MBM Corporation AEROCUT NANO - Manual (Page 17)

AeroCut nano OPERATION MANUAL
17
3.4 Feed size adjustment
Feed size Slit position
・Adjust through MANUSET screen.
Page 19
3.5 Slit position adjustment
Gauge
(InstaSet bar)
Slitter head
・Adjust the positions of the slitter heads
by moving the gauge (InstaSet bar).
・The gaps between the slitter heads are
not adjustable.
3.6 Cutting location adjustment (Guillotine)
MANUAL CONTROL screen Home screen
ADJUST screen
Stretch or shrink
Between Cutmark and
1st cut. [inch]
Between paper edge and
1st cut. [inch] Reset to factory
settings.
Input balance between the entered value in MANUSET and the actual finished size.
i.e. MANUSET:1.00”, Actual size:1.02” = Input -0.02”