MBM Corporation BINDERYMATE 2 - Manual (Page 15)

13
Caution
MAKE ALL ADJUSTMENTS WITH
THE POWER OFF AND THE
STITCHING HEAD IN NEUTRAL
POSITION! (Fig. 14)
In neutral position, the wire grip assembly
(Index A) is stopped at the top of the slot
in the face plate.
Stitching Adjustments
Best stitching performance will be assured if all
adjustments are made so that you get the following
results:
1. Good Cut-Off
2. Uniform Wire Draw
3. Equal Leg Length
4. Proper Clincher Alignment
5. Sufficient Compression
To Equalize Both Legs of Stitch
(Fig. 15)
1. Loosen the wire guide locking bolt (Index C).
2. Turn adjusting screw (Index D) clockwise to
shorten left leg of stitch; counter clockwise to
lenghten left leg.
3. Tap bracket (Index E) down before tightening
bolt (Index C).
General
Every Bindery Mate’s M2000 Head Stitcher has a
friction-type head which depends on smooth sliding
friction and proper timing to function correctly.
Preventative maintenance will go far to insure
trouble-free operation. Avoid production down time
by keeping your stitcher in top working condition at
all times.
Recommended Spare Parts
Like any equipment that has moving parts, certain
parts of your stitcher will be subjected to more
wear than others and require replacement. The
following listing includes all the parts required for
minimum maintenance and good operation of your
Bindery Mate.
PART NAME PART NO. QTY.
Wire Cutters CA9048 2
Grip CA9015D 1
Grip Spring CA168 1
Tension Roll Clip CA9124 2
Rotator CAA9038E 1
Clincher Points CA9083 2
Section
5
MAINTENANCE, TROUBLE
SHOOTING AND
ADJUSTMENTS
Figure 14
(CTTT2605T3 Scene 8)
Figure 15
(CTTT2605T3 Scene 9, 1)
E
C
D
A