MBM Corporation BINDERYMATE 2 - Manual (Page 33)

31
DISMANTLING DRIVE
CAUTION
Disconnect power to the machine
before any disassembly.
A
C
B
NOTE: Head must be removed prior
to dismantling drive
1. Remove hairpin cotter
2. Remove spool retainer.
3. Remove coil
of wire.
4. Remove wire
spool washer.
5. Remove conical
spring.
6. Remove wire
spool stud.
7. Remove cover screws.
8. Remove cover.
9. Remove circuit board by gently
sqreezing here and then lift off
circuit board.
Note: If replacing circuit board, unplug
connector terminal from circuit board after
removing board.
Circuit board support
Circuit board
10. Remove circuit board
bracket.
14. Unplug motor terminals.
11. Unplug cam switch
terminals.
12. Remove extension spring.
13. Unscrew flat head bolts (4) and
remove motor.
(QF27F15)
(QF27F16)
(QF27F17)