MBM Corporation BINDERYMATE 2 - Manual (Page 31)

29
REMOVING AND DISMANTLING M2000 HEAD
CAUTION
As a precautionary measure-When removing
the head from any stitching machine make
SURE that the power to the machine has been
turned OFF or disconnected.
B
A
C
D
(CTTT2605T3 Scene 17)
(CTTT2605T3 Scene 16) (CTTT2605T3 Scene 18)
Note: Before removing head use hand jog to make sure bender
bar is all the way up.
1. Cut wire at bracket
and secure.
2. Slip tension spring
from bracket.
3. Lift Bonnet Clamp
lever as shown.
4. Pull head froward
and off stitcher.
5. Loosen the top two
clip screws, and
remove clear guard
assembly.
6. Lift end of spring
out of rotator.
7. Swing spring up
to disengage.
Lift out.
8. Slip rotator operating cam
off.
9. P u l l
rotator
forward.
CAUTION
The rotator operating cam can be
installed backwards. Be sure to
read fand follow the instructions
on page 30 before reassembling.
10. R e m o v e
the upper
face plate
clips.
11. Remove the lower face plate clips.
12. Position grip
spring housing
b e t w e e n
tension pawl
spring retainer
and cutter
housing.
13. Remove the
face plate by
sliding face
plate to the left
and lifting up.
14. Remove the cutter
operating slide.
15. Remove the friction
plug and spring.
16. Remove rotator holder.
17. Remove
g r i p
r e l e a s e
slide.
(QF27F14)