MBM Corporation MBM 256 LS Folder - Manual (Page 11)

9
Rev. 03/05
Operating Manual Set Up
Support
Place the folding machine on a solid table or
stand in a position where the operator has
access to both ends of the machine as well as to
the operator side of the machine.
WARNING
Always use two people to lift and position the
machine. In addition to its weight, the size of
the machine can place a single person in an
awkward or unbalanced position.
Adequate space should be provided near the
machine for flat and folded documents.
Power
Connect the folding machine to a 120V or 220V
power outlet with the supplied cord to match
the voltage for which the machine is set. The
cord plugs into the socket (9) at the bottom
right corner of the feed end of the machine.
After set up is complete, the main power switch
(11) can be turned on to activate the machine.
The fuse drawer (10) contains two T3.15AL250V
fuses, one in the hot line and one in the neutral.
Both fuses must be in place for the folding
machine to operate.
WARNING
Unplug the power cord before removing the
fuse drawer.
Feed Table Extension
If the feed table extension (6) has been folded
up, pull the feed table extension latch (7) and
lower the extension to the operating position.
For sheets longer than 14”, pull out the long
paper support (32) to support the trailing edge
of the documents.
9
10
11
32
6
7
6. Feed Table Extension
7. Feed Table Extension Latch
(pull to release)
9. Power Cord Socket
10. Fuse Drawer
11. Main Power Switch
32. Long Paper Support
Voltage Setting
Indicator