MBM Corporation MBM 256 LS Folder - Manual (Page 15)

13
Rev. 03/05
Operating Manual Set Up
Document Preparation
And Loading
After raising the feed table, adjust the paper
thickness adjustment knob (28) to match the
stock on which the documents are printed.
The knob has six detented positions to adjust
for paper from thin to thick. The knob is
shown at the second tick mark for 20 pound
paper. As paper thickness increases, rotate the
knob clockwise.
NOTE
Paper feed characteristics vary depending on
humidity, paper surface, type of ink used to
print the document, and other factors.
Therefore, settings for one document of a given
thickness may not be the same as those for
another document of the same thickness. A cer-
tain amount of trial and error may be necessary
with this adjustment.
NOTE
Heated processes such as in copiers and laser
printers can cause paper to curl. Be sure the
documents are flat before loading them into
the folding machine. If necessary, reverse curl
the documents to flatten them.
NOTE
It may be possible to fold thicker sheets or spe-
cially finished paper on the folding machine. If
these will not run with the available range of
user settings, contact the local authorized
MBM Dealer or Distributor for assistance.
28
28. Paper Thickness
Adjustment Knob