Section 8: removing & installing screen and door, Installation, Removing the screen – Montigo R320 User Manual

Page 29: Removing the window, Reinstalling the door

Advertising
background image

Section 8: Removing & Installing Screen and Window

Removing the Screen:

Follow the steps below to remove, or install the R320* / R420*

Step 1: Prepare to Lift out Screen Assembly

Grip either end of the screen assembly and pull towards yourself.

The screen assembly is held to the unit by both friction and magnets.

Step 2: Lift out Window from Grooves

The window is removed by first lifting upward on the glass and then

by pulling the bottom out from the groove in which it was located (see

image below).

Removing the Window:

Follow the steps to remove, or install the R320*/R420* fireplace
window.

Reinstalling the door:

Follow the four previous steps to re-install the R-Series fireplace
window.

Before beginning any screen or glass removal, make sure that the unit

has not been in operation and that it is at room temperature.

Step 2: Lift out the Retaining Tabs and Screen.

The Retaining Tabs are quite long and in most cases, this task would

be better performed by two people.
Once the Retaining Tabs have come away from the Fireplace, lift the

screen away and store in a safe place. The Screen is very fragile and

can be easily torn, dented or deformed.

Refer to Figure 21a below.

Window Screen

Assembly

Retaining

Tabs (2x)

Ventilation slots

located at the bottom

of the Screen Assembly

Glass Panel

Glass Lifting

Tools

Figure 21a. Screen Removal.

Window Screen

Assembly

Retaining

Tabs (2x)

Ventilation slots

located at the bottom

of the Screen Assembly

Glass Panel

Glass Lifting

Tools

Figure 21c. Window Removal.

Step 1: Use Glass Lifting Tools to Remove Window

Use the Glass Lifting Tools that are included with your fireplace

(see image bove). Attach one to each end of the window pane.

Make certain that they are firmly attached and secure.

Figure 21b. Window Removal (using glass lifting tools).

Once the bottom of the window is clear of the fireplace, lower the

window down from the upper groove in which it was located.

Lift the window clear of the fireplace and store it in a safe place.

Note: Never re-use the window if it has been broken, scratched or

damaged in any way. The window is made of tempered glass, and

although tempered glass is very durable - nicks, scratches or chips

can seriously impact the window's strength.

R320 & R420 Power Vent Indoor Gas Fireplace

Page 29

XG0770 - 150105.1

Installation

Advertising
This manual is related to the following products: