Montigo P52DF - Manual (Page 22)

Page 22
P52DF* Indoor Gas Fireplace
XG0196 - 150204.3
Installation
Section 8: Installing & Removing the Door
Removing the door:
The P52DF* doors are removed in a few simple steps.
Follow these below to remove the Horizontal access panel,
unlatch the door buckles and, remove the door. Replace
in reverse order.
Remove the Horizontal Access Panel:
Figure 22a. Locate the door buckles.
Door Latch Hook
Door Latch Slot Hand-hold
Release the Door Buckles
Figure 22. Removing and installing the Horizontal .......
Access Panel
Figure 22b. Door buckle Tool
1
Step 4:
Firmly grasp hand-
hold end of Door
buckle tool and place
the machined end in
the slot under door
frame. (as shown)
Figure 22c.
Step 3:
Step 1:
Remove the Horizontal
cover by placing fingers
in both finger holes, then
pushing away from you
and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
2
Step 5:
Ensure the tool is firmly
in the lower end of
the slot, (as shown),
Then pull toward you
(Caution: hold the tool
securely).
3
Step 6:
Pull hard if necessary
to release the spring
tension. (Caution: The
latch springs back with
force, hold the tool
securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure
the latches are hanging
freely, the hook end
is released from the
bottom of the door.
(Repeat all 4-steps for
the remaining latches).
Figure 22d.
Figure 22e.
Figure 22f.
Locate the Door Buckles: Step 2:
Finger Holes
Installed Gas
Valve Cover
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.