RLE Protocol Converter V.2.4 - Manual (Page 40)

40 Protocol Converter User Guide 800.518.1519
3
Configuration
2 Click Submit Changes located in the upper left hand corner of the web page.
3 Once the changes have been accepted, click on Next>> link at the bottom of the page.
Threshold 1 Indicates the value that, when reached or exceeded,
causes the Protocol Converter to trigger an alarm.
Specify if the alarm should occur when the reading is less
than (<), Equal to (=) or greater than (>) the specified
threshold value.
Threshold 2 Indicates the value that, when reached or exceeded,
causes the Protocol Converter to trigger an alarm.
Specify if the alarm should occur when the reading is less
than (<), Equal to (=) or greater than (>) the specified
threshold value.
Alarm Delay The amount of time, in seconds, that passes between the
time an alarm condition occurs and the time the Protocol
Converter issues an alarm.
The default value of 0 indicates no delay.
Offline Delay The amount of time, in seconds, that elapses before the
Protocol Converter considers the register to be stalled or
offline.
The default value of 0 indicates no delay.
Current Age Indicates the amount of time, in seconds, since the
Protocol Converter last received an updated value.
Local Modbus Int Register The Modbus Integer data (whole number) used by a master
device polling the Protocol Converter.
Local Modbus Float Register The Modbus Float data (number with decimal) used by a
master device polling the Protocol Converter.
BACnet Instance The number used by a BACnet master for polling data from
the Protocol Converter.
Possible values include Analog Instance (AI) or Binary
Instance (BI).
SNMP register/Table OIDs The OID (Object Identifier) being polled from a SNMP
software. The Protocol Converter displays the OIDs used
for Integer data, Float data and the Label assigned.
SNMP modbus Device
Register/Table OID
Formatted to
BASE.DEVICENUMBER.REGISTERNUMBER where
BASE is the OID for this table, DEVICENUMBER is the
device’s number in the Protocol Converter (1-32) and the
REGISTERNUMBER reflects the appropriate device point
address.
Option Description
Table 3.6 SNMP Register Configuration Options