RLE Protocol Converter V.2.4 User Manual
Page 65
rletech.com
Protocol Converter User Guide
65
A
Load Firmware & Configuration Files
5
Click Upload.
One of three message displays:
♦
XML file upload complete.
♦
XML file cannot be upload - index base was not specified
. If this occurs, retry the
operation and specify a register number in the Index Base box.
♦
File has been uploaded - but type is unknown
. Proceed to step
6
If you want to revert to the preset registers or delete all registers, or if you attempted to
upload an unknown file type to a device, click the Preset/Delete link for that device.
Figure A.14
Preset/Delete Link on Device Configuration Webpage
7
The Preset/Delete dialog displays in a secondary browser window.
Figure A.15
Preset/Delete Dialog
8
Select one of two items from the drop-down:
Figure A.16
Drop-Down for Preset/Delete Dialog
9
Revert to the preset registers or delete all register information as follows:
♦
To revert to the preset values, indicate a Start Index number. This is the number of the
register at which you want to begin the preset operation.
If you choose to preset the register values, the following message displays when the
operation is complete:
8036 registers preset at index 1
♦
If you choose Delete Device/Registers, all device information will be deleted. Use this
option with caution.