Smithy Ez-Trol2 - Manual (Page 22)

NAVIGATING EZ-TROL II
THE EZ-TROL II TABS
EZ-Trol II’s interface is broken down into tabs. Each tab is given its own section in this manual that
describes the related functions. This chapter will only provide the operator with a brief description
of each tab and the conventions used to navigate the system.
Move from one section to another by left clicking with the mouse on the desired tab. Notice in the
screen below the blue circle located to the left of the word Manual. The blue circle indicates the
active tab. Navigation techniques will be discussed at the end of this chapter
AUTO TAB
The Auto Tab, shown below is the main screen used for executing the parts program. When EZ-Trol
is powered up note that the position coordinates are colored orange which means that the machine
must be homed. How to set-up and home the SmithyCNC machine tools will be discussed in the
next chapter. The functions of the Auto Tab screen will be explained in detail in a later chapter of
this manual.
Figure 7.1 Auto Tab Screenshot
7
16 | Toll Free 1-800-476-4849