SONOSAX SX-R4 (Firmware v3.1) - Manual (Page 20)

User manual SONOSAX SX-R4 Page 20 of 53
5.4 MONITORING
This Monitoring page is used to configure and mix the 10 tracks of the SX-R4 for it's headphone output.
The configuration of the monitoring is done by means of a specific menu as shown below :
The Monitoring is always configured per pair of tracks (10 tracks = 5 pairs of tracks).
The table below shows the available choices and their respective monitoring results on the stereo headphone
output for the pair of tracks 1 and 2:
Monitoring Mode Result on the Left channel Result on the Right channel
--- --- ---
MONO 1 + 2 1 + 2
STEREO 1 2
REV STEREO 2 1
MS 1 + 2 1 – 2
MONO L 1 + 2 ---
MONO R --- 1 + 2
The table below descibes the actions of the Joystick :
Joystick
Short pressure Long pressure
LEFT, RIGHT Change the monitoring mode
UP, DOWN Move the selector
CENTER Save the modifications and
return to the previous Menu
NOTE:
If a pair of tracks is not activated (not assigned) the only possible value is : " --- " (No
Monitoring)