Super Systems HP15 - Manual (Page 17)

HP 15 Manual Rev A Page 17 of 17
Alarm Settings – Page 3
This screen will allow the user to set the hysteresis and the on delay time
for the alarm. To set the hysteresis, press the value and enter the new
hysteresis value from the calculator. To set the On delay time, press the
value and enter the new On delay time from the calculator. Pressing the
<<<Back button will display page 2 of the Alarm Settings menu. Pressing
the Menu button will display the
Alarms menu.
Over Temp Alarm
If at any time the alarm setpoint is exceeded, the over temp alarm screen will
be displayed on the screen. This screen will remain displayed until the
acknowledge button, ACK, is pressed.
SSi Information Screen
On any screen where the Super Systems Inc logo is visible, the user will be
able to display the information screen for the HP 15. Press the logo to
display the screen. The information screen will display the
Super Systems Inc address and contact information, as well
as the screen version and the firmware version of the 9120.
The user can close out the screen either by pressing the Super Systems Inc
logo again, or by pressing the Close button.