Super Systems AC20 RS485 Modbus - Manual (Page 41)

Page 41/59
TITLE: MODBUS/J-BUS Protocol for SSi’s- AC20 ENG. 824E REV. 1
WORDS FOR DEVICE IN CONFIGURATION MODE – PARAMETERS
“C.Cn.” – Menu Conf. 3 – CONTROL OUTPUT CONFIGURATION
ADDRESS
(Decimal) DEC. Display R
W
R
Jbus Mod
Bus
DESCRIPTION FIGU-
RES
MNEM
CODE
E
A
D I
T
E
2214 2213 Decimal point position for secondary
control output display in eng. Unit
Range:
0 = No decimal figure
1 = One decimal figure
2 = Two decimal figure
N.A. (“SC.dP”) x x
2215 2214 Low scale range value for secondary
control output display in eng. unit See Mbus
word 302
or 2213
(“SC.E.L.”) x x
2216 2215 High scale range value for secondary
control output display in eng. unit See Mbus
word 302
or 2213
(“SC.E.H”) x x
2217 2216 Secondary control output auxiliary condi-
tioning
0 = The functions described in the note
are applied “Before” of the “Secondary
control output conditioning” stage
1 = The functions described in the note
are applied “After” of the “Secondary
control output conditioning” stage
Note:
a - Control output limiter
b - Control output max rate of rise
c - Control output display value
N.A. (“SC.A.C”) x x