1 power supply wiring, Relay output wiring – Tecfluid MX4 For FLOMAT Series User Manual
Page 17
Advertising
17
2.2.1 Power
supply
wiring
Before starting the installation of the equipment, check that the supply voltage available is
the same as marked on the label of the converter.
Terminal
Power supply AC
Power supply DC
8 Earth NC
9 Neutral -
10 Phase +
It is very important to connect the mains earth to the instruments with AC power supply
due to the presence of a mains filter inside the converter that uses this connection.
2.2.2 Relay
output
wiring
2
INSTALLATION OF THE ELECTRONIC CONVERTER
Advertising