AEC VacTrac Series Conveying Systems - Manual (Page 52)

Page 52 VacTrac™ Series Conveying Systems
WH2-605A.4 Mechanical Components
3-12 Installing ACA Series Filter Chambers
ACA Series filter chambers are shipped completely assembled to
reduce customer installation time. Several mounting arrangements
are available, depending on the mounting adapter supplied with the
unit.
ACA filter chambers are used with several different sizes of
vacuum hoppers, depending on the mounting adapter supplied with
the unit. Typical hopper sizes range from 0.7 cu. ft. to 6.0 cu. ft.
(19.8 liters to 169.9 liters); smaller hopper installations are also
possible. You must install a bottom flange adapter when
mounting the filter chamber to the vacuum hopper. The adapter
increases overall height of the filter chamber unit; this may affect
where you install the unit.
3-13 Making ACA Series Filter Chamber Electrical
Connections
!
WARNING
BE SAFETY CONSCIOUS!
High or low voltage can cause serious or fatal
injury.
Installation must be performed by qualified
personnel only!!
Always disconnect power source before
attempting installation or repair.