AEC FSS Series 1.5- 10 HP Fountain Solution Systems - Manual (Page 20)

FSS Series Fountain Solution Systems Page 19
IAE-600
2-6 Uncrating
FSS Series Portable Chiller Models 2 hp to 5 hp
FSS Series portable circulators are shipped mounted on a skid,
enclosed in a plastic wrapper, and contained in a cardboard box.
Remove the nails holding the box to the skid and lift the box off
carefully, avoiding staples in the 1’ x 4’ wood supports. Cut steel
banding.
Use a pry bar to remove the blocks securing the unit to the skid.
Insert forks between skid and portable chiller from the side until they
protrude beyond the opposite side of the unit. The forks must be
equidistant from the centerline of the unit and the unit must be
balanced on the forks.
Lift the unit off the skid with a fork truck. Lift slowly and only high
enough to clear the skid. Use a pry bar if necessary to carefully
remove the skid from the unit.
Lower slowly. The unit should land on its casters or rails and can then
be moved into position.
Temporary hardware has been installed to prevent side panels from
shifting in transit. Remove hardware.
Important!
Retain the crating material for reshipping the circulator in case hidden shipping
damage is found.
FSS Series Stand Alone Circulator Models 3 hp to 10 hp
FSS Series stand alone circulators are shipped mounted on a skid,
enclosed in a plastic wrapper, and open-crated on all four sides and
top.
1. Pry the crating away from the skid.
2. Repeat steps as noted above.
Important!
Never remove the unit from the front (electrical control end) or the rear (pipe
connection end) – DAMAGE MAY RESULT.