ARAG GCS 3200 - Manual (Page 26)

26
13.1 Speed
Usually the Job Computer calculates the speed by means of the data sent by the sensor installed on the equipment wheel.
In alternative, the speed can be calculated by means of the data sent on the ISOBUS line by the sensor placed on the tractor wheel.
In this menu carry out all settings to calculate the speed.
Fig. 51 Fig. 52
Select the source used for speed calculation.
Possible options:
ISOBUS : Par. 13.1.1
Wheel sensor : Par. 13.1.2
13.1.1 Source - ISOBUS
Fig. 53
The ISOBUS system receives speed data from the sensor placed on the tractor wheel.
No other settings are necessary.
USER SETTING