ARAG GCS 3200 - Manual (Page 9)

9
7 general precautions for a correct harness position
• Securing the cables:
- secure the harness so that it does not interfere with moving parts;
- route the harnesses so that they can not be damaged or broken by machine movements or twisting.
• Routing the cables to protect against water infiltrations:
- the cable branches must ALWAYS be face downwards (Fig. 8).
Fig. 8 Fig. 9
• Fitting the cables to the connection points:
- do not force the connectors by pushing too hard or bending them: the contacts may be damaged and computer operation may be compromised.
Use ONLY the cables and accessories indicated in the catalogue, having technical features suitable for the use to be made of them.
8 connecting the harness to control unit, hydraulic unit and available functions
• Use only the cables provided with the ARAG computers.
• Take care not to break, pull, tear or cut the cables.
• Use of unsuitable cables not provided by ARAG automatically voids the warranty.
• ARAG is not liable for damages to the equipment, persons, animals or things caused by failure to observe the above
instructions.
8.1 Job computer connection
WARNING: DO NOT CONNECT THE ISOBUS CONNECTOR (Fig. 4 on page 7).
IT MUST BE CONNECTED ONLY AFTER INSTALLING ALL COMPONENTS (Chapter 9 ISOBUS system cable connection).
For all other connections:
some connectors are supplied with separate slide: manually insert the guide in the most suitable position for the connection
insertion and removal.
Fig. 10
• Open connector slide ( 1, Fig. 10).
• To position connector ( 2), insert it inside socket
( 3) then press: during this operation, take care
not to bend the electric contacts.
• Close slide (
4) until it locks in place.
Connect harnesses as specified in Par. 6.2; each one of them shall be connected to the corresponding socket on the remote
control unit.
If they prove hard to insert, do not force them, but check the shown position.
INSTALLATION