ARAG GCS 3200 - Manual (Page 5)

5
INTRODUCTION
• Manual foreword and use
This manual provides instructions to assemble, connect and set the computers of the BRAVO 300S family.
Any other information is provided in specific sheets to be used exclusively by the installer, containing specific information of each computer model.
• Manual use Modes
The section of this manual dedicated to the installation contains information for installers. For this reason we have used technical terms without
providing explanations which would be necessary for end users only.
THE INSTALLATION MUST BE CARRIED OUT BY AUTHORISED AND SKILLED PERSONNEL ONLY. THE MANUFACTURER IS
NOT RESPONSIBLE FOR ANY OPERATION SPECIFIED IN THIS MANUAL CARRIED OUT BY UNAUTHORISED OR UNSKILLED
PERSONNEL.
• liMitations
The descriptions of the assembly phases refer to a "general" computer, so specific models will not be mentioned, unless a certain installation procedure
concerns exclusively one computer type.
• responsibility
The installer must carry out workmanlike installations and ensure to the end user the perfect operation of the whole system both with ARAG components
only and other brands' components.
ARAG always recommends using its components to install control systems.
The installer will be held responsible for any malfunction if he decides to use other brands' components even without actually changing the system
parts or harness.
The compatibility check with components and accessories of other manufacturers shall be carried out by the installer.
If the computer or the ARAG components installed together with other brands' components get damaged because of what stated above, no direct or
indirect warranty will be provided.