ARAG GCS 3200 - Manual (Page 39)

39
15.12 Treatment preliminary settings
set Par.
After having carried out the indicated settings start the
treatment selecting between "Manual" (Par. 15.12.1) o
"Automatic" (Par. 15.12.2) modes.
to be carried out
upon first use of
the coMputer
Speed 13.1
Jobs setup 13.2
Nozzles setup 13.3
Flowrate correction factor (if necessary) 13.5
Main page setting 13.8
to be carried
out before each
treatMent
Type of wheel 13.1
Flowrate correction factor 13.5
Type of job 13.2
Working limits 13.4
Tank parameter 14.1
Data reset (optional) 14.2.1
15.12.1 Automatic operation (DEFAULT)
Fig. 99
GCS3200 keeps the set application rate constant regardless
of the changes in speed and boom section status.
If necessary, during the spraying, it is possible to use the
relevant switch (Par. 15.2 o Par. 15.5) to adapt the output to
the crop conditions, temporarily increasing or reducing the
application rate up to ±50%.
1 Enable the automatic operation (Par. 15.9).
2a Open the desired section valves:
5/7-way version (Par. 15.2 o Par. 15.6).
2b Open the desired section valves:
sequential version (Par. 15.3 o Par. 15.6).
3 Position the tractor at the beginning of the field to be
sprayed.
4 Turn the main switch to ON.
(Par. 15.2 o Par. 15.11).
5 Start the treatment.
6 Use the control valve switch (Par. 15.2) or the relevant
buttons (Par. 15.5) to temporarily change the application rate.
15.12.2 Manual operation
Fig. 100
Rate manual regulation shall be carried out with the suitable
switch (Par. 15.2) or the relevant buttons (Par. 15.5).
1 Enable the manual operation. (Par. 15.9).
2a Open the desired section valves:
5/7-way version (Par. 15.2 o Par. 15.6).
2b Open the desired section valves:
sequential version (Par. 15.3 o Par. 15.6).
3 Position the tractor at the beginning of the field to be
sprayed.
4 Turn the main switch to ON.
(Par. 15.2 o Par. 15.11).
5 Start the treatment.
6 Use the control valve switch (Par. 15.2) or the relevant
buttons (Par. 15.5) to temporarily change the application rate.
USE